Timesaver > Overview
LAPPING COMPOUNDS
Please see Precision
Finish Booklet (PDF) or contact
us for complete directions for
use.
GUARANTEED NOT TO IMBED - WILL NOT CONTINUE TO CUT!
Timesaver lapping compound does not contain emery, aluminum
oxide, silicon-carbide or similar charging abrasives. They
are unconditionally guaranteed not to imbed into any metal surface.
Prepared in powder form, to be mixed with oil as used. Timesaver first
acts as an abrasive, then the particles diminish to a polish, and
finally to inert material. Directions for use in each can.
 |
YELLOW LABEL GRADES
FOR SOFT METALS
(Babbitt, Brass, Bronze and Aluminum)
#40 Coarse #60 Medium #80 Fine #100
Very fine
RECOMMENDED FOR: Fitting babbitt bearings, brass valves,
bronze bushings, bronze worm gears; fitting brass,
babbitt and other soft metal guides; cooling down hot
journal bearings without disassembly, and similar uses.
|
MSDS Data Sheet |
 |
GREEN LABEL GRADES
FOR HARD METALS
(Steel, Cast Iron, Hard Bronze and Stainless Steel)
#55 Coarse #77 Medium #111 Fine #333
Very fine
RECOMMENDED FOR: Removing tool and cutter marks, and
high spots from new steel and hard bronze gears; lapping-in
rebored cylinder walls, noisy gear units, or new replacement
gears; extreme precision fitting of small steel parts,
and similar uses.
|
MSDS
Data Sheet |
TIMESAVER PRODUCTS CO.
ESTABLISHED 1919
| |
Distribution
Richard F. Payne, Inc.
460 Podlin Drive
Franklin Park, IL 60131-100
Tel: (630)595-0350
Fax: (630)595-3685
|
Manufacturing & Distribution
Micro Surface Corporation
270 Hillsdale Ave.
San Jose, CA 95136
Tel: (408) 723-0700
Fax: (408) 723-0710
E-mail: info@ws2coating.com |
|
