Timesaver > Yellow Label Grade
Please see Precision
Finish Booklet (PDF) or contact
us for complete directions for use.
Mix TIMESAVER with oil as you use it and only the amount needed for
the particular job to be done. Keep well mixed.
SPLIT BEARINGS - Mix TIMESAVER COMPOUND with light or medium oil
to the consistency of a thin paste and apply to the bearing halves.
Add a little oil to the surfaces; also apply oil to the shaft. Both
up cap - not too tightly, just so shaft can be easily turned by hand;
then proceed to lap. At intervals add sufficient oil to the surfaces
to prevent them form becoming dry. Take up on bearings gradually as
high spots are removed, applying fresh compound when necessary.
SLEEVE BEARINGS - Fit bearings snugly to shaft. Apply TIMESAVER mixed
with oil to bearing and shaft. Insert shaft and lap with a twisting
motion, adding oil frequently until proper clearance is obtained.
Flush out with diesel or Stoddard Solvent.
HOT BEARINGS - Mix a small amount of TIMESAVER with oil. The mixture
must be very thin. Apply freely to bearings and shaft through oil
holes. Rotate the shaft. Add the thin mixture until bearing is free.
Then flush out with diesel or Stoddard Solvent.
GEARS - Mix TIMESAVER COMPOUND with oil proportions of about one
part TIMESAVER to three or four parts of oil (by volume). The use
of heavy oil is advisable as this procedure prevents the mixture from
being thrown from the gears and wasted. Apply mixture sparingly either
by pouring or with a paint brush. When gears run quietly, flush out
with diesel oil or Stoddard Solvent.
TIMESAVER COMPOUND will not imbed into any metal surface
and will
not continue to cut.
We also make HARD METAL LAPPING
COMPOUNDS
for lapping cast iron, steel, and hard bronze.
TIMESAVER PRODUCTS CO.
ESTABLISHED 1919
| |
Distribution
Richard F. Payne, Inc.
460 Podlin Drive
Franklin Park, IL 60131-100
Tel: (630)595-0350
Fax: (630)595-3685
|
Manufacturing & Distribution
Micro Surface Corporation
270 Hillsdale Ave.
San Jose, CA 95136
Tel: (408) 723-0700
Fax: (408) 723-0710
E-mail: info@ws2coating.com |
|